R&S ZNL Series - Page 879

Command reference
R&S
®
ZNL/ZNLE
879User Manual 1178.5966.02 ─ 20
<Key> Key for the key/value pair(s).
<Value> String or numeric value for the key/value pair(s). If a string
parameter is supplied, it has to be enclosed in single or double
quotes.
Example:
PROG:INIP 'c:\preferences\myapp',
'myparameter', 'myvalue', 'startf', 123.05
Write two key/value pairs into the file
c:\preferences\myapp.ini. The contents of the file look
like:
[PARAMETER]
myparameter="myvalue"
startf="123.05"
PROG:INIP? 'c:\preferences\myapp',
'myparameter'
Query the value of the key myparameter in the *.ini file. The
response is "myvalue".
PROGram[:SELected]:NAME <Program>
Selects the application to be run on the analyzer. At present, only the general parame-
ter PROG is available. This means that PROGram[:SELected]:EXECute can start
any program.
Tip: Use this command in order to avoid problems should the default value change in
future firmware versions.
Parameters:
<Program> PROG
Any program running under Windows or any file that can be
opened with an application program available on the analyzer.
*RST: PROG
Example: See PROGram[:SELected]:EXECute
PROGram[:SELected]:RETVal?
Queries the return value of an application or process started via PROGram[:
SELected]:EXECute.
This will only be successful if preceded by a PROGram[:SELected]:WAIT? query
(see PROGram[:SELected]:WAIT on page 880).
Example:
See PROGram[:SELected]:EXECute
Usage: Query only
VNA command reference