R&S ZNL Series - Page 998

Command reference
R&S
®
ZNL/ZNLE
998User Manual 1178.5966.02 ─ 20
SOURce<Ch>:LPORt<LogPt>:CLEar [<Scope>]
Dissolves balanced port <LogPt> or all logical ports.
Suffix:
<Ch>
.
Channel number
<LogPt> Logical port number used to number balanced ports.
Range according to the current port configuration
(SOURce<Ch>:LPORt<LogPt>). If an undefined balanced port
number is used, the analyzer generates an error message.
Exception: Parameter ALL, see below.
Setting parameters:
<Scope> ALL
If ALL is specified, all logical ports are dissolved; the <log_port>
suffix is ignored. If ALL is omitted, only the specified balanced
port is dissolved.
Example: See SOURce<Ch>:LPORt<LogPt>
Usage: Setting only
Manual operation: See "Select Predefined Port" on page 399
11.5.2.16 STATus commands
The STATus:... commands control the status reporting system. Status registers are
not reset by *RST; use *CLS for this purpose.
STATus:PRESet.............................................................................................................999
STATus:QUEStionable:CONDition?..................................................................................999
STATus:QUEStionable:INTegrity:CONDition?....................................................................999
STATus:QUEStionable:INTegrity:HARDware:CONDition?...................................................999
STATus:QUEStionable:LIMit<Lev>:CONDition?.................................................................999
STATus:QUEStionable:ENABle....................................................................................... 999
STATus:QUEStionable:INTegrity:ENABle..........................................................................999
STATus:QUEStionable:INTegrity:HARDware:ENABle.........................................................999
STATus:QUEStionable:LIMit<Lev>:ENABle.......................................................................999
STATus:QUEStionable[:EVENt]?....................................................................................1000
STATus:QUEStionable:INTegrity[:EVENt]?......................................................................1000
STATus:QUEStionable:INTegrity:HARDware[:EVENt]?.....................................................1000
STATus:QUEStionable:LIMit<Lev>[:EVENt]?...................................................................1000
STATus:QUEStionable:NTRansition...............................................................................1000
STATus:QUEStionable:INTegrity:NTRansition................................................................. 1000
STATus:QUEStionable:INTegrity:HARDware:NTRansition................................................ 1000
STATus:QUEStionable:LIMit<Lev>:NTRansition..............................................................1000
STATus:QUEStionable:PTRansition............................................................................... 1001
STATus:QUEStionable:INTegrity:PTRansition................................................................. 1001
STATus:QUEStionable:INTegrity:HARDware:PTRansition................................................ 1001
STATus:QUEStionable:LIMit<Lev>:PTRansition.............................................................. 1001
STATus:QUEue[:NEXT]?.............................................................................................. 1001
VNA command reference