R&S ZVB - Page 737

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 722
<Ch>
Number of an existing channel.
'<Ch_name>'
Channel name, e.g. 'Channel 4'.
*RST value
'Ch1'
SCPI, Command Types
Device-specific, command or query.
Example:
See CONFigure:CHANnel<Ch>:CATalog?
CONFigure:CHANnel<Ch>:NAME:ID? '<Ch_name>'
Queries the channel number (numeric suffix) of a channel with known channel name. A channel name
must be assigned before (CONFigure:CHANnel<Ch>NAME '<Ch_name>').
CONFigure:CHANnel<Ch>:CATalog? returns a list of all defined channels with their names.
<Ch>
Channel number. This suffix is not relevant and may be omitted (the command
returns the actual channel number).
'<Ch_name>'
Channel name, e.g. 'Channel 4'.
*RST value
–
SCPI, Command
Types
Device-specific, command or query.
Example:
See CONFigure:CHANnel<Ch>:CATalog?
CONFigure:CHANnel<Ch>:TRACe:REName '<Tr_name>'
Assigns a (new) name to the active trace in channel <Ch>.
<Ch>
Channel number.
'<Tr_name>'
Trace name, e.g. 'Trace 4'.
*RST value
–
SCPI, Command
Types
Device-specific, no query.
Example:
*RST; :CONF:CHAN:TRAC:REN 'Testtrace_1'
Reset the analyzer to create a default trace in channel 1 and set this trace as
the active trace. Rename the trace 'Testtrace_1'.
CALC:PAR:SDEF 'Testtrace_2', 'S11'
Create a new trace which will become the active trace in channel no. 1.
CONF:TRAC:REN 'Testtrace_1', 'Testtrace_3'
Rename the first trace (which is currently not active) 'Testtrace_3'.