R&S ZVB - Memory

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 763
INSTrument:PORT:COUNt?
Returns the number of test ports of the analyzer.
Response
Number of ports (integer number).
Range [def. unit]
1, 2, 3 or 4, depending on the analyzer model.
*RST value
–
SCPI, Command Types
Device-specific, query only.
Example:
INST:PORT:COUN?
Return the number of ports of your analyzer.
INSTrument[:SELect] CHANNEL1 | CHANNEL2 | CHANNEL3 | CHANNEL4
[Deprecated command]
Selects channel <Ch> as the active channel.
To select a channel number > 4 use the generalized command INSTrument:NSELect <Ch>.
Parameters
Number of the channel to be activated. The channel must be created before
using CONFigure:CHANnel<Ch>:STATe ON.
Range [def. unit]
CHANNEL1, CHANNEL2, CHANNEL3, CHANNEL4 [–]
*RST value
CHANNEL1
SCPI, Command
Types
Confirmed, command or query. If all channels have been deleted
(CONFigure:CHANnel<Ch>:STATe OFF) the query returns CHANNEL0.
Example:
CONF:CHAN2:STAT ON; :INST CHANNEL2
Create channel no. 2 and select it as the active channel.
MEMory...
The MEMory system controls the loaded setups of the analyzer.
The MEMory... commands don't affect any stored files. Use the MMEMory... commands to store and
load data and to manage files stored on a mass storage device.
MEMory:CATalog?
Returns the names of all loaded setups.
Response
Comma-separated list of all setups.
*RST value
'Set1' (the default setup is created after each *RST).
SCPI, Command
Types
Confirmed (with device-specific response), query only.