R&S ZVB - Initiate<Ch

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 760
SCPI, Command Types
Confirmed, command or query
Example:
HCOP:PAGE:ORI LAND; :HCOP
Select landscape page orientation and start printing.
HCOPy:PAGE:WINDow ACTive | ALL | SINGle
Defines the number of diagram areas per printed page.
This command is valid for printed hardcopies. If you print to a file (HCOPy:DESTination 'MMEM'),
use HCOPy:MPAGe:WINDow.
ACTive |
Print only active diagram area.
ALL |
All diagram areas are printed on one page.
SINGle
One diagram area per page.
*RST value
n/a (*RST does not affect the printer configuration)
SCPI, Command Types
Confirmed, command or query
Example:
HCOP:PAGE:WIND SING; :HCOP
Select one diagram area per page and start printing.
INITiate<Ch>...
This subsystem controls the initiation of the trigger system and defines the scope of the triggered
measurement.
INITiate<Ch>:CONTinuous <Boolean>
Qualifies whether the analyzer measures in single sweep or in continuous sweep mode.
<Ch>
Channel number. The channel is ignored because the command affects all
channels.
<Boolean>
ON - The analyzer measures continuously, repeating the current sweep.
OFF - The measurement is stopped after the number of sweeps defined via
[SENSe<Ch>:]SWEep:COUNt. INITiate<Ch>[:IMMediate] initiates a new
measurement cycle.
*RST value
ON
SCPI,
Command
Types
Confirmed, command or query
Example:
*RST; :INIT:CONT OFF
Activate single sweep mode for all channels (including channel no. 2 created later).
INIT:SCOP SING