R&S ZVB - Page 977

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 962
[SENSe<Ch>:]SWEep:COUNt <No_of_Sweeps>
Defines the number of sweeps to be measured in single sweep mode (INITiate<Ch>:CONTinuous
OFF).
<Ch>
Channel number. If the single sweep mode settings apply to all channels
(INITiate<Ch>[:IMMediate]:SCOPe ALL), this suffix is ignored; see
program example in section Single Sweep Mode.
<No_of_Sweeps>
Number of consecutive sweeps to be measured.
Range [def. unit]
1 to 999. [–]
*RST value
1
SCPI, Command
Types
Confirmed, command or query
Example:
See CALCulate<Chn>:DATA:NSWeep:FIRSt?.
[SENSe<Ch>:]SWEep:DETector:TIME <det_time>
Defines the detector observation time for ratios and wave quantities if a Peak or RMS detector is active.
The detector is selected together with the measured quantity (CALCulate<Ch>:PARameter:MEASure
or CALCulate<Ch>:PARameter:SDEFine).
<Ch>
Channel number.
<det_time>
Detector time.
Range [def. unit]
0 s to 3456000 s. [s]
*RST value
0.01 s
SCPI, Command
Types
Confirmed, command or query
Example:
*RST; :CALC:PAR:MEAS 'TRC1', 'a1D1RMS'
Select the wave quantity a1 for the default trace and activate the RMS
detector.
SWE:DET:TIME 1
Specify an observation time of 1 s at each sweep point.
[SENSe<Ch>:]SWEep:DWELl <delay>
Defines the Meas. Delay for each partial measurement. Setting a delay disables the automatic calculation
of the (minimum) sweep time; see [SENSe<Ch>:]SWEep:TIME:AUTO.
<Ch>
Channel number.
<delay>
Meas. delay before each partial measurement.
Range [def.
unit]
0 s to 3.179551E+002 s. [s] Changing the delay leaves the number of points
unchanged but has an impact on the duration of the sweep
([SENSe<Ch>:]SWEep:TIME).
*RST value
0 s