R&S ZVB - Page 978

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 963
SCPI,
Command
Types
Confirmed, command or query
Example:
FUNC "XFR:POW:S12"
Activate a frequency sweep and select the S-parameter S12 as measured
parameter for channel and trace no. 1.
SWE:TIME?
Query total sweep time.
SWE:DWEL 1
Set a delay of 1 s for each partial measurement.
SWE:TIME?
Query total sweep time. The time is extended by the delay times the total number
of partial measurements per sweep.
[SENSe<Ch>:]SWEep:POINts <no_points>
Defines the total number of measurement points per sweep (Number of Points).
<Ch>
Channel number 1.
<no_points>
Number of points per sweep.
Range [def. unit]
1 to 60001. [–]
*RST value
201
SCPI, Command
Types
Confirmed, command or query
Example:
FUNC "XFR:POW:S12"
Activate a frequency sweep and select the S-parameter S12 as measured
parameter for channel and trace no. 1.
SWE:TIME?
Query total sweep time.
SWE:POIN 2010
Multiply the (default) number of points by 10.
SWE:TIME?
Query total sweep time again. The analyzer estimates a sweep time that is
also multiplied by 10.
[SENSe<Ch>:]SWEep:SPACing LINear | LOGarithmic
[Deprecated command]
Defines the frequency vs. time characteristics of a frequency sweep (Lin. Frequency or Log Frequency).
The command has no effect on segmented frequency, power or time sweeps.