R&S ZVB - System

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1051
queue is empty.
SYSTem...
This subsystem collects the functions that are not related to instrument performance, such as functions for
general housekeeping and global configurations.
SYSTem:COMMunicate:AKAL:CONNection THRough | OPEN | SHORt | MATCh,
<port_1>, <port_2>
Connects the selected calibration standard to one or two ports of the active calibration unit (see
SYSTem:COMMunicate:RDEVice:AKAL:ADDRess).
THRough | OPEN |
SHORt | MATCh
Connected one or two-port standard
<port_1>
Port number of the calibration unit, for one and two-port standards
<port_2>
Second port number of the calibration unit, for two-port standards
(THRough) only, omitted for the one-port standards
*RST value
–
SCPI, Command Types
Device-specific, command or query
Example:
SYST:COMM:AKAL:CONN THR, 1, 2
Connect a trough standard between ports 1 and 2 of the cal unit.
SYSTem:COMMunicate:AKAL:MMEMory[:STATe] <Boolean>
Shows or hides the memory of the active calibration unit (see
SYSTem:COMMunicate:RDEVice:AKAL:ADDRess).
<Boolean>
ON – memory is shown in a separate drive
OFF – memory is not shown
*RST value
OFF
SCPI, Command Types
Device-specific, command or query
Example:
SYST:COMM:AKAL:MMEM ON
Show the memory of the active calibration unit.
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <address_no>
Sets the GPIB address of the analyzer.
<address_no>
GPIB address (integer number)
Range [def. unit]
0 to 30 [–].