R&S ZVB - Status

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1044
SCPI, Command
Types
Device-specific, command or query
Example:
*RST; SOUR:LPOR1 1,3
Reset the analyzer and combine the physical ports 1 and 3 to the logical port 1.
Defining a balanced port configuration deletes the default trace.
SOUR:TDIF ON
Switch true differential mode on.
SOUR:TDIF:WAV SEND
Select single-ended source power mode.
STATus...
This subsystem controls the Status Reporting System. Status registers are not reset by *RST; use *CLS
for this purpose.
STATus:PRESet
Configures the status reporting system such that device-dependent events are reported at a higher level.
The command affects only the transition filter registers, the ENABle registers, and queue enabling:
 The ENABle parts of the STATus:OPERation and STATus:QUEStionable... registers are set to all
1's.
 The PTRansition parts are set all 1's, the NTRansition parts are set to all 0's, so that only positive
transitions in the CONDition part are recognized.
The status reporting system is also affected by other commands, see Reset Values of the Status
Reporting System.
*RST value
–
SCPI, Command Types
Confirmed, no query
Example:
STAT:PRES
Preset the status registers.
STATus:QUEStionable:CONDition?
Returns the contents of the CONDition part of the QUEStionable register. Reading the CONDition
registers is nondestructive.
*RST value
–
SCPI, Command
Types
Confirmed, query only
Example:
STAT:QUES:COND?