R&S ZVB - Data Transfer

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Measurement Examples
Simple Measurement Tasks
Operating Manual 1145.1084.12 – 30 68
elements. The following examples show how to change the display colors.
To select or define a color scheme for the diagrams and their display elements ...
1. Click Display — Display Config — Color Scheme... to open the Color Scheme dialog.
2. Select the Predefined Scheme that is most appropriate for your needs.
3. Click Define User Scheme... to open the Define User Color Scheme dialog.
4. Select a display element from the Element drop-down list.
5. Click the Color field to open a standard Color dialog and assign the color.
You can repeat the last 2 steps for as many elements as you like. For traces, you can also select a Trace
Style and Trace Width. Your settings apply to all setups, they are permanent even after you close the
network analyzer application.
6. If you wish to use several color schemes in parallel, click Save to save your current color scheme
to a file.
7. If you wish to restore the original Predefined Scheme, click System — System Config... — Resets
— Reset Colors.
To change the marker colors...
When you create markers, their color is the same as the color of the associated trace. You can change the
marker colors using the Color Scheme dialog.
1. Click Display — Display Config — Color Scheme...
2. Click Define User Scheme... to open the Define User Color Scheme dialog.
3. Select Same Color for all Markers from the Element drop-down list.
4. Click the Color field to open a standard Color dialog and assign the color.
5. Click Use same Color for all Markers.
All markers are displayed with the same color, irrespective of the trace colors.
Data Transfer
The following examples show you how to perform basic tasks related to data transfer from and to the
analyzer.
To copy the active setup ...
1. Plug a USB stick into any of the USB type A connectors on the front or rear panel of the analyzer.
2. Click File — Save to open the Save As dialog.
3. Open the Save in: drop-down list and select the network drive labeled Removable Disk (most
likely, drive E:) as file location.
4. Select a File name and click Save to store the data to the disk and close the Save As dialog.
The default extension for setup files (*.zvx) is appended automatically.