R&S ZVB - Page 1060

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1045
Query the CONDition part of the QUEStionable register to check for
questionable instrument states.
STATus:QUEStionable:ENABle
Sets the enable mask which allows true conditions in the EVENt part of the QUEStionable register to be
reported in the summary bit. If a bit is 1 in the enable register and its associated event bit transitions to
true, a positive transition will occur in the summary bit (bit 3 of the STatus Byte).
<NRf>
0 to 65535 (decimal representation)
*RST value
– (see also Reset Values of the Status Reporting System)
SCPI, Command Types
Confirmed, command or query
Example:
STAT:QUES:ENABle 1536
Set bits no. 9 and 10 of the QUEStionable:ENABle register
STATus:QUEStionable[:EVENt]?
Returns the contents of the EVENt part of the QUEStionable register. Reading an EVENt register clears it.
*RST value
–
SCPI, Command
Types
Confirmed, query only
Example:
STAT:OPER?
Query the EVENt part of the OPERation register to check whether an event
has occurred since the last reading.
STATus:QUEStionable:NTRansition
Sets the negative transition filter. If a bit is set, a 1 to 0 transition in the corresponding bit of the associated
condition register causes a 1 to be written in the associated bit of the corresponding event register.
<NRf>
0 to 65535 (decimal representation)
*RST value
– (see also Reset Values of the Status Reporting System)
SCPI, Command Types
Confirmed, command or query
Example:
STAT:QUES:NTR 1536
Set bits no. 9 and 10 of the QUEStionable:NTRansition register