R&S ZVB - Page 773

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 758
SCPI, Command Types
Device-specific, command or query
Example:
See HCOPy:DESTination
HCOPy:MITem:TIME[:STATe] <Boolean>
Qualifies whether or not the printed file contains the current date and time.
This command is valid for screen content which is printed to a file (HCOPy:DESTination 'MMEM').
To configure hardcopies, use HCOPy:ITEM:TIME[:STATe].
<Boolean>
ON | OFF - Date and time is included or excluded.
*RST value
n/a (*RST does not affect the printer configuration)
SCPI, Command Types
Device-specific, command or query
Example:
See HCOPy:DESTination
HCOPy:MPAGe:WINDow ALL | ACTive | MARKer
Defines the diagram areas to be printed to file.
This command is valid for screen content which is printed to a file (HCOPy:DESTination 'MMEM').
To configure hardcopies, use HCOPy:PAGE:WINDow.
ALL |
All diagram areas are printed.
ACTive |
Only the active diagram area is printed.
MARKer
Only the Marker Info Field (Marker Table) is printed.
*RST value
n/a (*RST does not affect the print-to-file-configuration)
SCPI, Command Types
Confirmed, command or query
Example:
See HCOPy:DESTination
HCOPy:PAGE:MARGin:BOTTom <numeric_value>
Defines the distance between the bottom of the page and the bottom of the printed information.
<numeric_value>
Lower margin.
Range [def. unit]
0.01 mm to 10000 mm [mm]
*RST value
n/a (*RST does not affect the printer configuration)
SCPI, Command Types
Device-specific, command or query
Example:
HCOP:PAGE:MARG:BOTT 10; TOP 10
Set an upper and a lower margin of 1 cm.