R&S ZVB - Page 795

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 780
Command
Types
Example:
Assume that the current setup contains two channels numbered
1 and 2, respectively, and that sweep segments have been
defined for channel no. 1.
MMEM:STOR:SEGM 1, 'C:\Program Files\Rohde&Schwarz\Network
Analyzer\SweepSegments\Seg_Ch1.seglist'
Store the sweep segment definition of channel 1 to a sweep
segment file.
MMEM:LOAD:SEGM 2, 'C:\Program Files\Rohde&Schwarz\Network
Analyzer\SweepSegments\Seg_Ch1.seglist'
Load the previously created sweep segment file and use the
sweep segments for channel 2.
MMEMory:LOAD:STATe <numeric_value>,'<file_name>'
Loads configuration data from a specified setup file and sets the analyzer to the corresponding instrument
state.
<numeric_value>
1 (the <numeric_value> is used for compatibility with the SCPI standard but is
ignored).
<file_name>
String parameter to specify the name and directory of the setup file to be
loaded. The default extension (manual control) for setup files is *.zvx, although
other extensions are allowed. If no path is specified the analyzer searches the
current directory, to be queried with MMEMory:CDIRectory?.
*RST value
–
SCPI, Command
Types
Confirmed, no query.
Example:
MMEM:CDIR 'C:\Program Files\Rohde&Schwarz\Network Analyzer'
Set the active directory.
MMEM:STOR:STAT 1,'RecallSets\Setup_0413.zvx'
Store the current setup configuration in the file
Setup_0413.zvx in the default directory for setup files
C:\Program Files\Rohde&Schwarz\Network
Analyzer\RecallSets\Setup_0413.zvx.
MMEM:LOAD:STAT 1,'RecallSets\Setup_0413.zvx'
Re-load the settings stored in Setup_0413.zvx.