Renesas M32R/ECU Series

10
10-130
MULTIJUNCTION TIMERS
10.5 TMS (Input-Related 16-Bit Timer)
32180 Group User’s Manual (Rev.1.0)
10.5.5 TMS Counters (TMS0CT, TMS1CT)
TMS0 Counter (TMS0CT) <Address: H’0080 03C0>
TMS1 Counter (TMS1CT) <Address: H’0080 03D0>
b0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 b15
TMS0CT,TMS1CT
????????????????
<After reset: Undefined>
b Bit Name Function R W
0–15 TMS0CT, TMS1CT 16-bit counter value R W
Note: • This register must always be accessed in halfwords.
The TMS counters are a 16-bit up-counter, which starts counting when the timer is enabled (by writing to the
enable bit in software). The counters can be read on-the-fly.
10.5.6 TMS Measure Registers (TMS0MR3–0, TMS1MR3–0)
TMS0 Measure 3 Register (TMS0MR3) <Address: H’0080 03C2>
TMS0 Measure 2 Register (TMS0MR2) <Address: H’0080 03C4>
TMS0 Measure 1 Register (TMS0MR1) <Address: H’0080 03C6>
TMS0 Measure 0 Register (TMS0MR0) <Address: H’0080 03C8>
TMS1 Measure 3 Register (TMS1MR3) <Address: H’0080 03D2>
TMS1 Measure 2 Register (TMS1MR2) <Address: H’0080 03D4>
TMS1 Measure 1 Register (TMS1MR1) <Address: H’0080 03D6>
TMS1 Measure 0 Register (TMS1MR0) <Address: H’0080 03D8>
b01234567891011121314b15
TMS0MR3–0,TMS1MR3–0
????????????????
<After reset: Undefined>
b Bit Name Function R W
0–15 TMS0MR3-TMS0MR0 16-bit measured value R –
TMS1MR3-TMS1MR0
Notes: • This register is a read-only register.
• This register can be accessed in either byte or halfword.
The TMS measure registers are used to latch counter contents upon event input. The TMS measure registers
are a read-only register.