13
13-34
32180 Group User’s Manual (Rev.1.0)
CAN MODULE
13.2 CAN Module Related Registers
CAN0 Single-Shot Interrupt Request Enable Register (CAN0SSIEN)
<Address: H
’0080 1048>CAN1 Single-Shot Interrupt Request Enable Register (CAN1SSIEN)
<Address: H
’0080 1448>b0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 b15
SSIEN0 SSIEN1 SSIEN2 SSIEN3 SSIEN4 SSIEN5 SSIEN6 SSIEN7 SSIEN8 SSIEN9 SSIEN10 SSIEN11 SSIEN12 SSIEN13 SSIEN14 SSIEN15
0000000000000000
<After reset: H’0000>
b Bit Name Function R W
0 SSIEN0 0: Disable interrupt request R W
Slot 0 single-shot interrupt request enable bit 1: Enable interrupt request
1 SSIEN1
Slot 1 single-shot interrupt request enable bit
2 SSIEN2
Slot 2 single-shot interrupt request enable bit
3 SSIEN3
Slot 3 single-shot interrupt request enable bit
4 SSIEN4
Slot 4 single-shot interrupt request enable bit
5 SSIEN5
Slot 5 single-shot interrupt request enable bit
6 SSIEN6
Slot 6 single-shot interrupt request enable bit
7 SSIEN7
Slot 7 single-shot interrupt request enable bit
8 SSIEN8
Slot 8 single-shot interrupt request enable bit
9 SSIEN9
Slot 9 single-shot interrupt request enable bit
10 SSIEN10
Slot 10 single-shot interrupt request enable bit
11 SSIEN11
Slot 11 single-shot interrupt request enable bit
12 SSIEN12
Slot 12 single-shot interrupt request enable bit
13 SSIEN13
Slot 13 single-shot interrupt request enable bit
14 SSIEN14
Slot 14 single-shot interrupt request enable bit
15 SSIEN15
Slot 15 single-shot interrupt request enable bit
This register is used to enable or disable the interrupt requests that will be generated when transmission in each
corresponding slot has failed. Setting any bit in this register to "1" enables the interrupt request to be generated
when transmission in the corresponding slot (in single-shot mode only) has failed. The CAN Single-Shot Inter-
rupt Request Status Register helps to know which slot requested the interrupt.
To Next Page
Loading...
Need help?
General
