Remote Control
R&S
®
FSVA/FSV
686Operating Manual 1176.7510.02 ─ 09
Example:
CALC:MARK:FUNC:FPE:SORT Y
Sets the sort mode to decreasing y values
CALC:MARK:FUNC:FPE 3
Searches the 3 highest maxima for trace 1
CALC:MARK:FUNC:FPE:COUN?
Queries the number of maxima found
CALC:MARK:FUNC:FPE:X?
Queries the frequencies (span <> 0) or. time (span = 0) of the
maxima found
107.5E6,153.8E6,187.9E6
frequencies in increasing order
2.05E-3,2.37E-3, 3.71e-3
times in increasing order
Manual operation:
See "Marker Peak List" on page 293
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:Y?
This command queries the position of the peaks on the y-axis.
The order depends on the sort order that has been set with CALCulate<n>:
MARKer<m>:FUNCtion:FPEaks:SORT on page 684.
The number of peaks on the number that has been set with CALCulate<n>:
MARKer<m>:FUNCtion:FPEaks:COUNt?.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Return values:
<PeakPosition> Position of the peaks on the y-axis. The unit depends on the
measurement.
Example:
CALC:MARK:FUNC:FPE:SORT Y
Sets the sort mode to decreasing y values
CALC:MARK:FUNC:FPE 3
Searches the 3 highest maxima for trace 1
CALC:MARK:FUNC:FPE:COUN?
Queries the number of maxima found
CALC:MARK:FUNC:FPE:Y?
Queries the levels of the maxima found
Usage: Query only
Manual operation: See "Marker Peak List" on page 293
CALCulate<n>:MARKer<m>:FUNCtion:MDEPth:RESult?
This command queries the results of the AM modulation depth measurement..
Remote Control – Commands
To Next Page
Loading...
