Remote Control
R&S
®
FSVA/FSV
708Operating Manual 1176.7510.02 ─ 09
Example:
CALC:MARK3:SGR:SAR VIS
CALC:MARK3:SGR:XY:MIN
Activates and positions marker 3 on the minimum level in the
visible Spectrogram.
Usage: Event
Manual operation: See "Marker Search Type" on page 306
CALCulate<n>:MARKer<m>:SGRam:Y:MAXimum:ABOVe
This command positions the specified marker on the next peak level of the vertical
axis. The search includes only frames above the current marker position. It does not
change the horizontal position of the marker.
The command is available for the spectrogram.
Suffix:
<n>
.
1...4
Selects the measurement window.
<m> 1...16
Selects the marker.
Example:
CALC:MARK2:SGR:Y:MAX
Activates and positions marker 2 on the peak level of the y-axis.
CALC:MARK2:SGR:Y:MAX:ABV
Positions marker 2 on the next higher level found in the diagram
area above the current marker position.
Usage: Event
Manual operation: See "Search Mode for Next Peak in Y Direction" on page 305
CALCulate<n>:MARKer<m>:SGRam:Y:MAXimum:BELow
This command positions the specified marker on the next peak level of the vertical
axis. The search includes only frames below the current marker position. It does not
change the horizontal position of the marker.
The command is available for the spectrogram.
Suffix:
<n>
.
1...4
Selects the measurement window.
<m> 1...16
Selects the marker.
Example:
CALC:MARK2:SGR:Y:MAX
Activates and positions marker 2 on the peak level of the y-axis.
CALC:MARK2:SGR:Y:MAX:BEL
Positions marker 2 on the next higher level found in the diagram
area below the current marker position.
Remote Control – Commands
To Next Page
Loading...
