Rohde & Schwarz FSVA - Page 769

Remote Control
R&S
®
FSVA/FSV
769Operating Manual 1176.7510.02 ─ 09
MMEMory:STORe:SGRam............................................................................................. 770
MMEMory:STORe<n>:SPURious.................................................................................... 771
MMEMory:STORe<n>:TRACe.........................................................................................771
MMEMory:LOAD:IQ:STATe 1, <FileName>
This command loads the I/Q data from the specified .iq.tar file.
Note: switch to single sweep mode (INIT:CONT OFF) before importing I/Q data as
otherwise the instrument will continue to measure data and display the current results
rather than the imported data.
Parameters:
<FileName> Complete file name including the path
Example:
MMEM:LOAD:IQ:STAT 1, 'C:
\R_S\Instr\user\data.iq.tar'
Loads I/Q data from the specified file.
Usage: Setting only
Manual operation: See "IQ Import" on page 201
MMEMory:STORe:IQ:STATe 1, <FileName>
This command stores the complex I/Q data to the specified .iq.tar file in 32-bit float-
ing point format.
Parameters:
<FileName> Complete file name including the path
Example:
MMEM:STOR:IQ:STAT 1, 'C:
\R_S\Instr\user\data.iq.tar'
Stores I/Q data to the specified file.
Manual operation: See "IQ Export" on page 201
MMEMory:STORe:IQ:COMM <Description>
Defines a description of the export file which is stored with the data and also displayed
in the file selection dialog box for I/Q data import and export.
Parameters:
<Description>
Example:
MMEM:STOR:IQ:COMM 'Device test 1b'
Creates a description for the export file.
MMEM:STOR:IQ:STAT 1, 'C:
\R_S\Instr\user\data.iq.tar'
Stores I/Q data and the comment to the specified file.
Manual operation: See "IQ Export" on page 201
Remote Control – Commands