Remote Control
R&S
®
FSVA/FSV
809Operating Manual 1176.7510.02 ─ 09
zero span. A new trigger event is required for each test point (exception: trigger "FREE
RUN").
The results are output as a list in the order of the entered frequency points. The num-
ber of results per test point depends on the number of concurrently active measure-
ments (peak/RMS/average). The number of frequencies is limited to 200 entries.
Selection of concurrently active measurements and setting of parameters that are con-
stant for the whole measurement is performed via a configuration command ( [SENSe:
]LIST:POWer:SET). This also includes the setting for trigger and gate parameters.
Settings that are not directly included in commands of this subsystem can be config-
ured by sending the corresponding commands prior to the SENSe:LIST Subsystem
commands.
Please note that changes to the trigger level have to be executed in zero span in order
to take effect for the SENSe:LIST Subsystem commands.
The sweep list cannot be configured using remote commands during an on-going
sweep operation.
The following subsystem is included:
"SENSe:LIST:RANGe Subsystem" on page 814
Further information
●
"SENSe:LIST Subsystem" on page 808
More details on the SENSe:LIST Subsystem
The following setting parameters can be selected independently for each frequency
point:
●
analyzer frequency
●
reference level
●
resolution filter
●
resolution bandwidth
●
video bandwidth
●
measurement time
●
detector
The commands of this subsystem can be used in two different ways:
●
Instrument setup, measurement and querying of the results in a single command
line. With this method, there is the least delay between the measurement and the
result output. However, it requires the control computer to wait for the response
from the instrument.
●
Instrument setup and querying of the result list at the end of the measurement:
With this method, the control computer may be used for other activities while the
measurement is being performed. However, more time is needed for synchroniza-
tion via service request.
Remote Control – Commands
To Next Page
Loading...
