Rohde & Schwarz FSVA - Page 810

Remote Control
R&S
®
FSVA/FSV
810Operating Manual 1176.7510.02 ─ 09
[SENSe:]LIST:POWer:RESult?........................................................................................810
[SENSe:]LIST:POWer[:SEQuence].................................................................................. 810
[SENSe:]LIST:POWer:SET............................................................................................. 813
[SENSe:]LIST:POWer:STATe..........................................................................................814
[SENSe:]LIST:POWer:RESult?
This command queries the results of the list evaluation.
This command may be used to obtain measurement results in an asynchronous way,
using the service request mechanism for synchronization to the end of the measure-
ment.
If there are no results, the command returns an error.
Return values:
<PowerLevel> Power level for each frequency included in the measurement.
The command returns up to 3 power levels for each frequency,
depending on the number of evaluation modes you have turned
on with [SENSe:]LIST:POWer:SET on page 813.
The result is a list of floating point values separated by commas.
The unit depends on [SENSe:]LIST:POWer[:SEQuence].
Example:
*ESE 1
*SRE 32
Configuration of the status reporting system for the generation of
an SRQ on operation complete
SENSe:LIST:POWer
935.2 MHz,-20dBm,10dB,OFF,NORM,1 MHz,3 MHz,
434us,0,
935.4 MHz,-20dBm,10dB,10dB,NORM,30 kHz,100 kHz,
434us,0,
935.6 MHz,-20dBm,10dB,20dB,NORM,30 kHz,100 kHz,
434us,0;
*OPC
Configuring and starting the measurement
...
Further actions of the control computer during measurement
On SRQ:
SENSe:LIST:POWer:RESult?
Response to service request
Usage:
Query only
[SENSe:]LIST:POWer[:SEQuence]
<Frequency>,<RefLevel>,<RfAtt>,<ElAtt>,<FilterType>,<RBW>,<VBW>,<Meas
Time>,<TriggerLevel>
This command configures and initiates the List Evaluation measurement.
The list can contain up to 200 entries (frequencies). You can define a different instru-
ment setup for each frequency that is in the list.
Remote Control – Commands