Rohde & Schwarz FSVA - Page 819

Remote Control
R&S
®
FSVA/FSV
819Operating Manual 1176.7510.02 ─ 09
Manual operation: See "RF Attenuator" on page 379
[SENSe:]LIST:RANGe<range>:INPut:ATTenuation:AUTO <State>
This command activates or deactivates the automatic RF attenuation setting for the
specified range.
Suffix:
<range>
.
1...20
range
Parameters:
<State> ON | OFF
*RST: ON
Example:
LIST:RANG2:INP:ATT:AUTO OFF
Deactivates the RF attenuation auto mode for range 2.
Manual operation: See "RF Att. Mode" on page 379
[SENSe:]LIST:RANGe<range>:INPut:GAIN:STATe <State>
This command switches the preamplifier on or off for the specified range.
Suffix:
<range>
.
1...20
range
Parameters:
<State> ON | OFF
*RST: OFF
Example:
LIST:RANG3:INP:GAIN:STATe ON
Switches the preamplifier for range 3 on or off.
Manual operation: See "Preamp" on page 379
[SENSe:]LIST:RANGe<range>:LIMit:STARt <Limit>
This command sets an absolute limit value at the start frequency of the specified
range. Different from manual operation, this setting is independent of the defined limit
check type.
Suffix:
<range>
.
1...20
range
Parameters:
<Limit> -400 to in 400 dBm
*RST: 13 dBm
Remote Control – Commands