Rohde & Schwarz FSVA - Page 949

Remote Control
R&S
®
FSVA/FSV
949Operating Manual 1176.7510.02 ─ 09
Usage: Event
SCPI confirmed
Manual operation: See "Save File / Recall File" on page 198
MMEMory:STORe<n>:STATe:NEXT
This command stores the current device settings in a *.dfl file. The file name used in
the last saving process is automatically counted up to the next unused name.
Suffix:
<n>
.
irrelevant
Example:
MMEM:STOR:STAT 1,'Save'
Saves the current device settings in the file Save.dfl.
MMEM:STOR:STAT:NEXT
Saves the current device settings in the file Save_001.dfl
MMEM:STOR:STAT:NEXT
Saves the current device settings in the file Save_002.dfl
Usage: Event
Manual operation: See "Save File / Recall File" on page 198
MMEMory:USER<Softkey> <Filename>, <Label>
This command defines the settings file to be loaded when the specified user-definable
softkey is selected. The settings file must exist, otherwise an error occurs.
Suffix:
<Softkey>
.
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8
Number of the softkey in the "User" menu.
Parameters:
<Filename> string
This parameter defines the path and file name of the settings to
be loaded.
<Label> string
This parameter defines the label of the user-definable softkey.
*RST: User<Softkey_number>
Example:
MMEM:USER1 'C:\MySaveSets\Set1','Set1'
Loads settings file Set1 when the "Set1" softkey in the "User"
menu is selected.
Example:
MMEM:USER3 'C:\MySaveSets\Set3',''
Loads settings file Set3 when the "User3" softkey in the "User"
menu is selected.
Remote Control – Commands