Remote Control
R&S
®
FSVA/FSV
971Operating Manual 1176.7510.02 ─ 09
SYSTem:PSA:WIDeband <State>
This command defines which option is returned when the *OPT? query is executed,
depending on the state of the wideband option.
It is only available for PSA89600 emulation.
Parameters:
<State> ON | OFF | HIGH
OFF
The option is indicated as "B7J"
ON
The 40 MHz wideband is used.
The option is indicated as "B7J, 140".
HIGH
The 80 MHz wideband is used.
The option is indicated as "B7J, 122".
*RST: OFF
Manual operation: See "Wideband" on page 183
SYSTem:REBoot
This command reboots the instrument, including the operating system.
Usage:
Event
SYSTem:REVision:FACTory
Resets the response to the REV? query to the default value, e.g. after a user string
was defined using the SYSTem:REVision[:STRing] command. (REV? query availa-
ble for HP emulation only, see Chapter 4.2.5, "GPIB Commands of HP Models 856xE,
8566A/B, 8568A/B and 8594E", on page 974.)
Example:
Define the system language:
SYST:LANG '8563E'
Set the response back to factory setting:
SYS:REV:FACT
Query the revision:
REV?
Response:
920528
Usage: Event
SCPI confirmed
Manual operation: See "REV String Factory" on page 183
Remote Control – Commands
To Next Page
Loading...
