Rohde & Schwarz R&S SMB100B - Source > Noise Generator Settings

Analog modulations
R&S
®
SMB100B
104User Manual 1178.3711.02 ─ 08
Coupling (AC/DC)
Selects the coupling mode (AC or DC) for the external signal.
"AC"
Disconnects the DC voltage component and uses only the AC com-
ponent of the modulation signal.
"DC"
Uses the modulation signal with both components, AC and DC.
Remote command:
[:SOURce<hw>]:INPut:MODext:COUPling on page 460
Impedance
Sets the impedance for the externally supplied signal.
Remote command:
[:SOURce<hw>]:INPut:MODext:IMPedance<ch> on page 460
Bandwidth
Displays the maximum bandwidth of the external LF signal.
Remote command:
[:SOURce]:LFOutput<ch>:BANDwidth? on page 464
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
5.4.7.3 Source > noise generator settings
Access:
► Select "Modulation" > "Modulation Sources > Noise Generator".
The "Noise Generator" settings contain all parameters to configure the signal of the
internal noise generator.
Modulation settings