Rohde & Schwarz R&S SMB100B - Display and Keyboard Settings

General instrument functions
R&S
®
SMB100B
228User Manual 1178.3711.02 ─ 08
In detail described in the following paragraphs, you can:
●
Set display and keyboard language, see Chapter 10.1.1, "Display and keyboard
settings", on page 228
●
Set date and time for the system clock, see Chapter 15.3.2, "Date and time",
on page 592
●
Configure and activate a Screen Saver
●
Deactivate display update to improve performance, see Chapter 10.1.2, "Display
update settings", on page 229
●
Determine the state of the RF signal, and the level display in the status bar when
you turn on the R&S SMB100B, see Chapter 10.1.3, "Defining the RF signal state
on power on", on page 230.
10.1.1 Display and keyboard settings
Access:
1. Select "System Config > Setup > User Interface > Display/Keyboard > Display".
2. Select "Display/Keyboard > USB Keyboard".
In the "Display/Keyboard" dialog, you can change regional and language options
for the GUI and an external keyboard, and define the screen saver settings.
The remote commands required to configure the display and keyboard are described in
Chapter 12.9, "DISPlay subsystem", on page 382 and Chapter 12.12, "KBOard sub-
system", on page 393.
Screen Saver.............................................................................................................. 229
Wait Time.................................................................................................................... 229
Display........................................................................................................................ 229
RF Hardkey.................................................................................................................229
USB Keyboard > Layout..............................................................................................229
Customizing the user interface