Rohde & Schwarz R&S SMB100B - NRP Power Viewer Settings

Improving level performance
R&S
®
SMB100B
174User Manual 1178.3711.02 ─ 08
also compensates the noise that superimposes the measured signal (e.g. from a
broadband amplifier).
Related settings and functions
●
Measurements-related settings, like results, filter, filter length:
Chapter 7.4.3.2, "NRP power viewer settings", on page 174
●
Software version of the connected power sensor:
:SENSe<ch>[:POWer]:TYPE? on page 411
●
Acquisition of level correction data:
Chapter 7.3, "User correction", on page 156
Additional information
See Rohde & Schwarz website http://www.rohde-schwarz.com in section "Power
Meters & Voltmeters" for:
●
R&S NRP power sensor manual.
●
Information on the R&S NRP-Z5 sensor hub and the available accessories.
●
Sensor software updates.
7.4.3.2 NRP power viewer settings
Access:
► Select "Power Sens" > "NRP Power Viewer".
Using power sensors