Rohde & Schwarz R&S SMB100B - Table of Contents

Improving level performance
R&S
®
SMB100B
176User Manual 1178.3711.02 ─ 08
└ Display.......................................................................................................... 177
└ Permanent.......................................................................................... 177
└ Display................................................................................................177
└ Use Frequency Of.........................................................................................177
└ Frequency.....................................................................................................177
└ Level Offset State,Level Offset..................................................................... 177
└ Filter..............................................................................................................178
└ Filter Length..................................................................................................178
└ Noise/Signal Ratio........................................................................................ 178
└ Auto Once.....................................................................................................178
└ Timeout......................................................................................................... 179
└ Default Aperture Time...................................................................................179
└ Aperture Time............................................................................................... 179
└ S-Parameter..................................................................................................179
└ Enable Logging.............................................................................................179
Sensor type and serial number
Indicates the type and the serial number of a selected R&S NRP power sensor, and
the channel the sensor is assigned to.
The displayed Level (Peak) / Level (Average) values correspond to the particular sen-
sor.
Remote command:
:SENSe<ch>[:POWer]:TYPE? on page 411
:SENSe<ch>[:POWer]:SNUMber? on page 409
Level (Peak) / Level (Average)
Indicates the measured peak or average level value.
You can also change the unit for the results display: Watt, dBm or dBμV.
Note: Peak level measurements are provided if the power sensor supports this feature.
Remote command:
:READ<ch>[:POWer]? on page 403
:SENSe<ch>:UNIT[:POWer] on page 403
Sensor Mapping
Accesses the NRP sensor mapping dialog.
Sensor settings
One tab per sensor provides the corresponding settings.
State ← Sensor settings
Activates level measurement.
Remote command:
:INITiate<hw>[:POWer]:CONTinuous on page 402
To query the availability of a sensor at a given connector, use the command :
SENSe<ch>[:POWer]:STATus[:DEVice]? on page 410.
Zero ← Sensor settings
Activates the auto zeroing.
Using power sensors