Rohde & Schwarz R&S SMB100B - Pulse External; Trigger Settings

Analog modulations
R&S
®
SMB100B
98User Manual 1178.3711.02 ─ 08
5.4.6 Pulse external / trigger settings
Access:
► Select "Modulation" > "Pulse Modulation > Pulse External / Trigger".
The dialog specifies some characteristics of the Pulse Ext. connector.
This connector is common for the pulse generator and the pulse modulator. For an
overview, see "Input and output connectors" on page 69.
Settings
Polarity.......................................................................................................................... 98
Impedance.................................................................................................................... 98
Show Connector............................................................................................................98
Polarity
Sets the polarity of the active slope of a pulse input signal, that is the external pulse
modulation signal.
Remote command:
[:SOURce<hw>]:PULM:POLarity on page 432
Impedance
Sets the input impedance.
Remote command:
[:SOURce<hw>]:PULM:IMPedance on page 432
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
Modulation settings