File and data management
R&S
®
SMB100B
215User Manual 1178.3711.02 ─ 08
If the connection does not succeed, consider to check the following:
●
Is the network folder or computer you try to map turned on?
●
Is the network folder or computer enabled for remote access?
●
Does the selected user name have the necessary permissions?
See also Chapter 9.9.5, "Using a file server for test files exchange", on page 220.
9.9 How to transfer files from and to the instrument
As explained in "File handling" on page 194, you access the file system of the
R&S SMB100B via one of the following ways:
●
Via the built-in "File Manager"
See Chapter 9.8, "Using the file manager", on page 209.
●
On an instrument connected to a LAN:
– Via one of the standard functions FTP or SMB (samba)
See Chapter 9.9.2, "Accessing the file system of the R&S SMB100B over
FTP", on page 217 and
Chapter 9.9.3, "Accessing the R&S SMB100B file system using SMB
(Samba)", on page 218
– Via mapped network drives
See Chapter 9.8.4, "How to map a network folder", on page 213.
●
Via a connected USB storage device
See Chapter 9.9.4, "Using a USB storage device for file transfer", on page 220
Mainly because of security reasons, the access to the file system of your
R&S SMB100B can be denied, because one or all these access methods are deliber-
ately disabled. Access to the file system via LAN and/or USB requires that the corre-
sponding service is enabled and a write access to the file system is enabled. Refer to
How to transfer files from and to the instrument
To Next Page
Loading...
