Rohde & Schwarz R&S SMB100B - GPIB Address Settings

Network operation and remote control
R&S
®
SMB100B
291User Manual 1178.3711.02 ─ 08
Remote command:
:SYSTem:COMMunicate:NETWork:RESource? on page 530
Socket
Displays the visa resource string for remote control over LAN, using the socket com-
munication protocol.
See also Chapter 11.2.1, "LAN interface", on page 269
Remote command:
:SYSTem:COMMunicate:SOCKet:RESource? on page 533
GPIB
Displays the visa resource string for remote control over the GPIB interface.
See also Chapter 11.2.3, "GPIB interface (IEC/IEEE bus interface)", on page 272.
Remote command:
:SYSTem:COMMunicate:HISLip:RESource? on page 529
USB
Displays the visa resource string for remote control over the USB interface.
See also Chapter 11.2.2, "USB interface", on page 271
Remote command:
:SYSTem:COMMunicate:USB:RESource? on page 533
SERIAL
Displays the visa resource string for remote control over the serial interface.
See also Chapter 11.2.2, "USB interface", on page 271
Remote command:
:SYSTem:COMMunicate:SERial:RESource? on page 532
11.5.3 GPIB address settings
Access:
► Select "System Config > Remote Access > GPIB Address".
The "GPIB Address" enables you to select the channel for remote control over the
IEC/IEE bus interface.
The remote command to configure the setting remotely is described in Chapter 12.16,
"SYSTem subsystem", on page 517.
Remote access settings