Rohde & Schwarz R&S SMB100B - Sense, READ, Initiate and Slist Subsystems

Remote control commands
R&S
®
SMB100B
396User Manual 1178.3711.02 ─ 08
Example:
:OUTPut1:AMODe FIXed
:OUTPut1:AFIXed:RANGe:UPPer?
// -27
:OUTPut1:AFIXed:RANGe:LOW?
// -50
Usage: Query only
Manual operation: See "Level Range" on page 153
:OUTPut<hw>:PROTection:CLEar
Resets the protective circuit after it has been tripped.
To define the output state, use the command :OUTPut<hw>[:STATe].
Example:
:OUTPut1:PROT:CLE
Resets the protective circuit of the RF output.
Usage: Event
Manual operation: See "Overload" on page 153
:OUTPut<hw>:PROTection:TRIPped?
Queries the state of the protective circuit.
Return values:
<Tripped> 1 | ON | 0 | OFF
*RST: 0
Example:
:OUTPut1:PROT:TRIP
queries the state of the protective circuit of the RF output.
Response: 0
the protective circuit has not tripped.
Usage: Query only
Manual operation: See "Overload" on page 153
12.14 SENSe, READ, INITiate and SLISt subsystems
These subsystems contain the commands for configuring the power measurements
with R&S NRP power sensor connected to the R&S SMB100B.
SENSe, READ, INITiate and SLISt subsystems