Network operation and remote control
R&S
®
SMB100B
314User Manual 1178.3711.02 ─ 08
●
"message": indicates the type of the message. Possible values and related mes-
sage contents are:
– > = incoming command
– < = outgoing response to a query
– E = error message, denoted in red
– T = execution time, i.e. time required by the instrument to process the com-
mand internally
11.6.2.3 Datasheet
The data sheet functionality allows you to retrieve the specification data of the instru-
ment at the time of delivery.
The document contains all specified value ranges and information of the data sheet, for
example important as reference values for recalibration.
11.7
To configure the instrument for remote access
The R&S SMB100B is equipped with a network interface and can be connected to an
Ethernet LAN (local area network).
There are two methods to establish a LAN connection to the instrument:
●
A non-dedicated network (Ethernet) connection from the instrument to an existing
network.
●
A dedicated network connection (Point-to-point connection) between the instru-
ment and a single computer.
How to: see Chapter 3.1.7, "Connecting to LAN", on page 27.
For identification in the network, all devices require an IP address.
To configure the instrument for remote access
To Next Page
Loading...
