Rohde & Schwarz R&S SMB100B - How to Enable the VNC Service; To Operate the Instrument Using VNC

Network operation and remote control
R&S
®
SMB100B
340User Manual 1178.3711.02 ─ 08
Finding out the SCPI command using the online help
If you are looking for the remote command to a function in manual operation, you find it
in the description of the online help.
1. To find out the SCPI command of a parameter in manual operation, select the
respective parameter.
2. To open the corresponding help topic, select one of the following:
● In the display, select "context-sensitive menu > Help".
● On the front panel, press the [Help] key.
The help topic opens. Apart from the function description, it contains the SCPI
command in detailed syntax.
How to find the corresponding GUI function to a command
Conversely, if you are looking for a function in the GUI, which belongs to a SCPI, you
find it via a cross-reference in the online help and in the user manual.
11.14 To operate the instrument using VNC
This section shows you some examples of the various possibilities to set up remote
operation.
●
Using a desktop system
– Chapter 11.14.2.1, "Using a web browser", on page 341
– Chapter 11.14.2.2, "Using a VNC client software", on page 341
●
Using a smart device
– Chapter 11.14.3.1, "Using a VNC app", on page 344
– Chapter 11.14.3.2, "Using a web browser with HTML5", on page 345
– Chapter 11.14.3.3, "Special mode QR code", on page 345
11.14.1 How to enable the VNC service
1.
NOTICE! Enabled VNC service can lead to unauthorized access.
Change the computer name and password of the instrument.
See Chapter 10.4.5, "How to prevent unauthorized access", on page 260.
2. Select "System Config > Setup > Security > Security > LAN Services".
3. Select "VNC > On".
4. Enter the Security Password.
To operate the instrument using VNC