Rohde & Schwarz R&S SMB100B - Setting Security Parameters; Update Policy Security Settings

General instrument functions
R&S
®
SMB100B
250User Manual 1178.3711.02 ─ 08
The remote commands required to unlock a protected stage are described in Chap-
ter 12.16, "SYSTem subsystem", on page 517.
Protection Level/Password
Unlocks the selected level of protection, if you enter the correct password.
The default protection level 1 password is 123456.
To lock the protection level again, clear the checkbox.
Remote command:
:SYSTem:PROTect<ch>[:STATe] on page 527
10.4.2 Setting security parameters
Access:
► Select "System Config > Setup > Security > Security > General".
In the "General" tab, you can determine the security level for firmware updates, and
configure the security settings for the mass memory and manual operation.
All modified settings in this dialog are not applied until you enter the Security Password
and confirm with Accept.
10.4.2.1 Update policy security settings
Access:
► Select "System Config > Setup > Security > Security > General > SW Update".
Using the security settings