Rohde & Schwarz R&S SMB100B - List Mode Settings

Remote control commands
R&S
®
SMB100B
477User Manual 1178.3711.02 ─ 08
SOUR1:LIST:DEXC:EXEC
// Query the available ASCII files with extension .csv
SOUR1:LIST:DEXC:AFIL:CAT?
// Response: "list1ASCII"
// Deactivate the list mode
SOUR1:FREQ:MODE CW
● List mode settings................................................................................................. 477
● List mode file operation.........................................................................................482
● List mode data exchange......................................................................................485
12.15.6.1 List mode settings
With the following commands, you can create list mode data, select the trigger mode
and determine the dwell time.
[:SOURce<hw>]:LIST:DWELl.......................................................................................... 477
[:SOURce<hw>]:LIST:DWELl:MODE................................................................................478
[:SOURce<hw>]:LIST:DWELl:LIST...................................................................................478
[:SOURce<hw>]:LIST:DWELl:LIST:POINts?......................................................................478
[:SOURce<hw>]:LIST:FREQuency...................................................................................479
[:SOURce<hw>]:LIST:FREQuency:POINts?......................................................................479
[:SOURce<hw>]:LIST:INDex............................................................................................479
[:SOURce<hw>]:LIST:INDex:STARt................................................................................. 480
[:SOURce<hw>]:LIST:INDex:STOP..................................................................................480
[:SOURce<hw>]:LIST:MODE...........................................................................................480
[:SOURce<hw>]:LIST:POWer..........................................................................................480
[:SOURce<hw>]:LIST:POWer:POINts?.............................................................................481
[:SOURce<hw>]:LIST:TRIGger:EXECute..........................................................................481
[:SOURce<hw>]:LIST:TRIGger:SOURce.......................................................................... 481
[:SOURce<hw>]:LIST:RUNNing?.....................................................................................482
[:SOURce<hw>]:LIST:DWELl <Dwell>
Sets the global dwell time. The instrument generates the signal with the frequency /
power value pairs of each list entry for that particular period.
See also Significant parameters and functions.
Parameters:
<Dwell> float
Range: 1E-3 to 100
Increment: 1E-6
*RST: 0.01
Example: See Example"Create an RF list and activate the list mode"
on page 474.
Manual operation: See "Global Dwell Time" on page 141
SOURce subsystem