Rohde & Schwarz R&S SMB100B - Page 479

Remote control commands
R&S
®
SMB100B
479User Manual 1178.3711.02 ─ 08
[:SOURce<hw>]:LIST:FREQuency <Frequency>
Enters the frequency values in the selected list.
Parameters:
<Frequency> <Frequency#1>{, <Frequency#2>, ...} | block data
You can either enter the data as a list of numbers, or as binary
block data.
The list of numbers can be of any length, with the list entries
separated by commas.
In binary block format, 8 (4) bytes are always interpreted as a
floating-point number with double accuracy.
See also :FORMat[:DATA].
Range: 300 kHz to RFmax (depends on the installed
options)
Example: See Example"Create an RF list and activate the list mode"
on page 474.
Manual operation: See "Edit List Mode Data" on page 146
[:SOURce<hw>]:LIST:FREQuency:POINts?
Queries the number (points) of frequency entries in the seleced list.
Return values:
<Points> integer
Range: 0 to INT_MAX
*RST: 0
Example: See Example"Create an RF list and activate the list mode"
on page 474.
Usage: Query only
[:SOURce<hw>]:LIST:INDex <Index>
Sets the list index in LIST:MODE STEP.
After the trigger signal, the instrument processes the frequency and level settings of
the selected index.
Parameters:
<Index> integer
*RST: 0
Example: See Example"Create an RF list and activate the list mode"
on page 474.
Manual operation: See "Current Index" on page 140
SOURce subsystem