Rohde & Schwarz R&S SMB100B - Source > External Settings; Trapezoid High; Trapezoid Rise; Fall; Triangle Rise

Analog modulations
R&S
®
SMB100B
103User Manual 1178.3711.02 ─ 08
Triangle Rise
Sets the time required for the triangle signal to change from low level to high level.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:RISE on page 470
Trapezoid Rise / Fall
Sets the time required for the trapezoid signal to change from low level to high level,
and vice versa.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:RISE on page 470
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:FALL on page 469
Trapezoid High
Sets how long the trapezoid signal is at high level.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:HIGH on page 469
5.4.7.2 Source > external settings
Access:
► Select "Modulation" > "Modulation Sources > External".
The "External" settings section contains all parameters required to configure the
signal of an externally supplied LF signal.
Settings
Coupling (AC/DC)....................................................................................................... 104
Impedance.................................................................................................................. 104
Bandwidth................................................................................................................... 104
Show Connector..........................................................................................................104
Modulation settings