List and sweep mode
R&S
®
SMB100B
145User Manual 1178.3711.02 ─ 08
6.7 List editor
The "User Correction" and "List Mode" dialogs provide a build-in list editor for defining
the corresponding value pairs.
The table and navigation functions of the UCOR and list mode editors have the same
structure and are therefore summarized below. The access is specified for both modes,
the fields and functions are explained using the example of the list mode.
Access to "Edit List Mode Data":
► "Sweep" > "List Mode" > "List Mode Data" > "Edit List Mode Data"
The editor for list mode provides a table with RF frequency and power values, an
extra column for defining variable dwell times, and standard navigation functions.
The remote commands required to define the list mode data are described in
Chapter 12.15.6, "SOURce:LIST subsystem", on page 474.
List editor
To Next Page
Loading...
