Rohde & Schwarz R&S SMB100B - Activating RF Signal Output; How to Set the Frequency and Level

RF signal configuration
R&S
®
SMB100B
58User Manual 1178.3711.02 ─ 08
The RF signal is based on a list of predefined frequency and level values pairs
and step widths.
See Chapter 6, "List and sweep mode", on page 112.
4.1 Activating RF signal output
By default, the RF output signal is deactivated.
To activate the RF output signal
1. Configure the RF signal as required.
Set, for example, the frequency and level values.
2. Activate the RF output in one of the following ways:
a) Select "Level" > "RF ON" > "On"
b) Press the [RF on/off] key at the front panel.
When activated, the "RF On" icon in the "Level" tile turns blue.
RF State/RF ON............................................................................................................58
RF output impedance....................................................................................................58
RF State/RF ON
Activates or deactivates the RF output.
Acts as the [RF on/off] key.
Remote command:
:OUTPut<hw>[:STATe] on page 394
RF output impedance
You can query the impedance of the RF output.
Remote command:
:OUTPut<hw>:IMPedance? on page 395
4.2 How to set the frequency and level
The simplest form of the RF signal is a continuous wave (CW) of constant frequency
and amplitude. The RF signal is defined by its frequency, level and phase.
To configure the RF signal.
1. Use one of the following:
How to set the frequency and level