General instrument functions
R&S
®
SMB100B
231User Manual 1178.3711.02 ─ 08
The setting is not affected by an instrument preset ([Preset] key or *RST) and the
"Save/Recall" function. It is reset only by factory preset.
Remote command:
[:SOURce<hw>]:POWer:EMF:STATe on page 494
10.1.4 How to set the initial instrument settings
This section describes how to set up the R&S SMB100B initially.
10.1.4.1 Setting the keyboard language
You can select the language of the external keyboard connected to the instrument.
To adjust the keyboard settings
1. Press the [Setup] key.
2. Select "User Interface > Keyboard".
3. Select the "Layout".
The dialog closes and the changes take effect immediately.
10.1.4.2 Setting the screen saver
You can enable a screen saver that automatically turns off the display after a user-
defined period of time. The screen saver is activated if no settings are made on the
touch screen, or via keys or the rotary knob during the selected wait time.
To activate the screen saver
1. Press the [Setup] key.
2. Select "User Interface > Display"
3. Activate the "Screen Saver".
Customizing the user interface
To Next Page
Loading...
