Network operation and remote control
R&S
®
SMB100B
333User Manual 1178.3711.02 ─ 08
Executing a SCPI script
A SCPI script primarily runs on the controller PC. In addition, you can execute a script
directly on the instrument, by assigning the script to the [★ (User)] key.
See Chapter 10.2.4, "How to assign actions to the [★ (User)] key", on page 238.
11.13.1 Show SCPI command
Access:
1. Select the parameter.
2. Open the context-sensitive menu (tap and hold).
3. Select "Show SCPI Command".
This function provides the syntax of the remote command with the current setting.
Copy
Copies the command and the current setting.
Close
Exits the "SCPI Command" dialog.
11.13.2 Displaying an SCPI list
The instrument displays a recorded SCPI list and thus provides viewing the recorded
results before exporting.
► Depending on the starting point, you can access the "SCPI Recording List" dialog
as follows:
● During recording
Select "Show SCPI Recording List" in the context-sensitive menu.
● At any time outside recording
Select "Show SCPI Recording List" in the context-sensitive menu.
This function assumes that at least one recording has been executed after
power-on.
● At the end of the recording
Select "Stop automatic SCPI recording". The dialog opens automatically.
● After you have exported the script to a file.
Select "SCPI Recording Export > Show file content"
To automate tasks with remote command scripts
To Next Page
Loading...
