Rohde & Schwarz R&S SMB100B - Execute Single Sweep; Frequency Range Settings; Reset Sweep; Show Connector

List and sweep mode
R&S
®
SMB100B
134User Manual 1178.3711.02 ─ 08
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
Reset Sweep
Resets a sweep.
With the next trigger event, the sweep starts at the initial value.
Remote command:
[:SOURce<hw>]:SWEep:RESet[:ALL] on page 517
Execute Single Sweep
In "Mode = Single", starts a sweep manually.
Remote command:
RF frequency sweep:
[:SOURce<hw>]:SWEep[:FREQuency]:EXECute on page 512
:TRIGger<hw>:FSWeep[:IMMediate] on page 550
RF level sweep:
[:SOURce<hw>]:SWEep:POWer:EXECute on page 512
:TRIGger<hw>:PSWeep[:IMMediate] on page 550
RF combined sweep:
[:SOURce<hw>]:SWEep:COMBined:EXECute on page 515
LF frequency sweep:
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute on page 471
:TRIGger<hw>:LFFSweep:IMMediate on page 550
General:
:TRIGger<hw>[:SWEep][:IMMediate] on page 550
6.5.2 Frequency range settings
Access:
1. Select for example "Sweep" > "RF Frequency Sweep"
2. Select for example "Frequency Range".
> "Frequency Range" > "Frequency / Level Range"
Sweep mode settings