Rohde & Schwarz R&S SMB100B - Page 512

Remote control commands
R&S
®
SMB100B
512User Manual 1178.3711.02 ─ 08
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Spacing" on page 133
[:SOURce<hw>]:SWEep:POWer:SHAPe <Shape>
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe <Shape>
Determines the waveform shape for a frequency sweep sequence.
Parameters:
<Shape> SAWTooth | TRIangle
*RST: SAWTooth
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Shape" on page 131
[:SOURce<hw>]:SWEep:POWer:EXECute
[:SOURce<hw>]:SWEep[:FREQuency]:EXECute
Executes an RF frequency sweep.
The command performs a single sweep and is therefore only effective in manual
sweep mode.
Example:
See Example"Setup an RF frequency or power sweep"
on page 506.
Usage: Event
Manual operation: See "Execute Single Sweep" on page 134
[:SOURce<hw>]:SWEep:POWer:RETRace <State>
[:SOURce<hw>]:SWEep[:FREQuency]:RETRace <State>
Activates that the signal changes to the start frequency value while it is waiting for the
next trigger event.
You can enable this feature, when you are working with sawtooth shapes in sweep
mode "Single" or "External Single".
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Retrace" on page 131
SOURce subsystem