Rohde & Schwarz R&S SMB100B - Display Subsystem

Remote control commands
R&S
®
SMB100B
382User Manual 1178.3711.02 ─ 08
12.9 DISPlay subsystem
The DISPlay system contains the commands to set the power-save mode of the
instrument.
Programming Examples
Example: Activating screen saver mode and display update
Use the following commands to switch on the screen saver of your instrument or to
automatic display. These settings are particularly useful when you control the instru-
ment remotely.
// Set the wait time interval and activate the screen saver
DISPlay:PSAVe:HOLDoff 10
DISPlay:PSAVe:STATe ON
// Disable the display of the current frequency and level values in remote control
DISPlay:ANNotation:ALL ON
// DISPlay:ANNotation:FREQuency ON
// DISPlay:ANNotation:AMPLitude ON
// Enable automatic update of the display at defined time intervals
DISPlay:UPDate[:STATe] ON
Example: Querying the dialog IDs, opening and closing dialogs
Use the following commands to query the dialog IDs of all currently open dialogs. The
dialog ID is a prerequisite for opening and closing dialogs via the remote control.
The dialog ID is also required to define user key actions.
See Chapter 10.2.4, "How to assign actions to the [★ (User)] key", on page 238.
// Query the dialog IDs of all open dialogs
DISPlay:DIALog:ID?
// CEUtraDLGenSetDlg,_,$A DlgKeyRf_Rosc
// Open and close dialogs via remote control
DISPlay:DIALog:OPEN "CEUtraDLGenSetDlg,_,$A"
DISPlay:DIALog:OPEN "DlgKeyRf_Rosc"
DISPlay:DIALog:CLOSe "DlgKeyRf_Rosc"
DISPlay:DIALog:CLOSe:ALL
:DISPlay:PSAVe:HOLDoff............................................................................................... 383
:DISPlay:PSAVe[:STATe].................................................................................................383
:DISPlay:BRIGhtness..................................................................................................... 383
:DISPlay:BUTTon:BRIGhtness.........................................................................................384
:DISPlay:UPDate[:STATe]............................................................................................... 384
:DISPlay:ANNotation:AMPLitude..................................................................................... 384
:DISPlay:ANNotation:FREQuency....................................................................................384
DISPlay subsystem