Rohde & Schwarz R&S SMB100B - Format Subsystem

Remote control commands
R&S
®
SMB100B
386User Manual 1178.3711.02 ─ 08
:DISPlay:DIALog:OPEN <DialogId>
Opens the specified dialog.
Setting parameters:
<DialogId> string
To find out the dialog identifier, use the query :DISPlay:
DIALog:ID?.
The <DialogName> part of the query result is mandatory.
Example: See Example"Querying the dialog IDs, opening and closing dia-
logs" on page 382
Usage: Setting only
Manual operation: See "SCPI" on page 237
:DISPlay:DIALog:CLOSe <DialogId>
Closes the specified dialog.
Setting parameters:
<DialogId> string
To find out the dialog identifier, use the query :DISPlay:
DIALog:ID?.
The <DialogName> part of the query result is sufficient.
Example: See Example"Querying the dialog IDs, opening and closing dia-
logs" on page 382
Usage: Setting only
:DISPlay:DIALog:CLOSe:ALL
Closes all open dialogs.
Example:
See Example"Querying the dialog IDs, opening and closing dia-
logs" on page 382
Usage: Event
12.10 FORMat subsystem
The commands in the FORMat subsystem determine the format of data returned by the
R&S SMB100B to the controller. This affects all query commands that return a list of
numerical data or block data, noted in the descriptions of the commands. The set data
format applies to both paths.
:FORMat:BORDer..........................................................................................................387
:FORMat:SREGister.......................................................................................................387
:FORMat[:DATA]............................................................................................................ 387
FORMat subsystem