Getting started
R&S
®
SMB100B
28User Manual 1178.3711.02 ─ 08
3.1.8 Connecting USB devices
You can connect or disconnect all USB devices from the R&S SMB100B during opera-
tion.
To connect USB storage devices
USB storage devices, such as memory sticks, allow data transfer from or to the
R&S SMB100B. You can also use them for firmware updates.
► Connect the USB storage device to any of the USB connectors.
To connect USB devices with external power supply
1.
NOTICE! Connected devices with external power supply can feed back current into
the 5 V power supply of the USB interface and thus damage the R&S SMB100B.
Ensure that there is no connection between the positive pole of the power supply
and the +5 V power pin of the USB interface (VBUS).
2. Connect the USB storage device to any of the USB connectors on the front panel
or rear panel.
To connect a keyboard
► Connect the keyboard to any of the USB connectors on the front panel or rear
panel.
When connected, the R&S SMB100B detects the keyboard automatically. A detected
keyboard has the default layout English – US.
To connect a mouse
► Connect the mouse to any of the USB connectors.
When connected, the R&S SMB100B detects the mouse automatically.
To connect power sensors
You can connect power sensors of the R&S NRP families to any of the USB connec-
tors on the front panel or rear panel.
See Chapter 7.4, "Using power sensors", on page 168.
3.1.9 Connecting to RF coaxial connectors
Here, you find information on how to prepare and to connect to RF coaxial connectors
of the R&S SMB100B. Use these RF connectors, for example, for output of the RF sig-
nal or for input of an external reference signal.
Preparing for use
To Next Page
Loading...
