Rohde & Schwarz R&S SMB100B - Modulation Settings; Pulse Modulation Settings

Analog modulations
R&S
®
SMB100B
71User Manual 1178.3711.02 ─ 08
5.4 Modulation settings
Access:
► Select "Modulation" > "Modulation Sources".
The "Modulation" dialog contains all functions and settings to configure the analog
modulations, the LF signal sources for performing a modulation, and the LF signal
output.
The remote commands required to define these settings are described in:
● Chapter 12.15.1.2, "SOURce:AM subsystem", on page 413
● Chapter 12.15.1.3, "SOURce:FM subsystem", on page 417
● Chapter 12.15.1.4, "SOURce:PM subsystem", on page 422
● Chapter 12.15.1.5, "SOURce:PULM subsystem", on page 427
● Chapter 12.15.1.6, "SOURce:STEReo subsystem", on page 438
● Chapter 12.15.5, "SOURce:LFOutput subsystem", on page 461
5.4.1 Pulse modulation settings
Option: see Chapter 5.1, "Required options", on page 68.
Access:
► Select "Modulation" > "Pulse Modulation".
The "Pulse Modulation" dialog contains all parameters required to configure the
pulse modulator and the pulse generator.
It also displays the pulse signal graphically.
For an overview of the supported signals sources and related connectors, see Chap-
ter 5.2, "Modulation types and signal sources", on page 68.
The remote commands required to define these settings are described in Chap-
ter 12.15.1.5, "SOURce:PULM subsystem", on page 427.
Modulation settings