Rohde & Schwarz R&S SMB100B - Source:frequency Subsystem

Remote control commands
R&S
®
SMB100B
454User Manual 1178.3711.02 ─ 08
Parameters:
<Filename> string
Filename or complete file path; file extension can be omitted.
Example: See Example"User correction data exchange" on page 448 .
Manual operation: See "Select Source/Select ASCII Destination" on page 96
12.15.3 SOURce:FREQuency subsystem
The SOURce:FREQuency subsystem contains the commands used to define the fre-
quency settings for the RF sources and sweeps.
Example: Frequency configuration
SOURce1:FREQuency:MODE CW
SOURce1:FREQuency:CW 6000000000
SOURce1:FREQuency:OFFSet 2000000000
SOURce1:FREQuency:MULTiplier 1.5
SOURce1:FREQuency:CW?
// 11000000000
// SOURce1:FREQuency:STEP:MODE USER
// SOURce1:FREQuency:STEP:INCRement 1000000
// SOURce1:FREQuency:CW UP
SOURce1:PHASe 2
SOURce1:PHASe:REFerence
[:SOURce<hw>]:FREQuency:MODE................................................................................454
[:SOURce<hw>]:FREQuency[:CW|FIXed].........................................................................455
[:SOURce<hw>]:FREQuency[:CW|FIXed]:RCL................................................................. 456
[:SOURce<hw>]:FREQuency:MANual..............................................................................457
[:SOURce<hw>]:FREQuency:MULTiplier.......................................................................... 457
[:SOURce<hw>]:FREQuency:OFFSet.............................................................................. 457
[:SOURce<hw>]:FREQuency:CENTer..............................................................................458
[:SOURce<hw>]:FREQuency:SPAN.................................................................................458
[:SOURce<hw>]:FREQuency:STARt................................................................................ 458
[:SOURce<hw>]:FREQuency:STOP.................................................................................459
[:SOURce<hw>]:FREQuency:STEP:MODE...................................................................... 459
[:SOURce<hw>]:FREQuency:STEP[:INCRement]............................................................. 460
[:SOURce<hw>]:FREQuency:MODE <Mode>
Sets the frequency mode for generating the RF output signal. The selected mode
determines the parameters to be used for further frequency settings.
Parameters:
<Mode> CW | FIXed | SWEep | LIST | COMBined
SOURce subsystem