Rohde & Schwarz R&S SMB100B - Special Mode QR Code; Using a Web Browser with HTML5

Network operation and remote control
R&S
®
SMB100B
345User Manual 1178.3711.02 ─ 08
11.14.3.2 Using a web browser with HTML5
The R&S SMB100B supports remote operation from a smart device via VNC with any
HTML5 compliant web browser, like Internet Explorer, Firefox, Google Chrome, or
Safari for instance.
To operate the instrument remotely via a web browser, proceed as follows:
1. In the web browser enter the IP address of the instrument, e.g. http://10.113.1.151.
2. Type the instrument IP address in the address field of the web browser on your PC,
e.g. http://10.113.1.151
The VNC authentication screen appears.
3. Enter the password and confirm with "OK".
The default password is instrument.
See Chapter 10.4.5, "How to prevent unauthorized access", on page 260.
After the connection is established, the current screen of the signal generator is
displayed and the instrument can be remotely operated.
11.14.3.3 Special mode QR code
If your smart device is equipped with a camera and a QR code reader, you can scan
the instrument's IP address or access the instrument with the Safari web browser.
QR code readers are available from various manufacturers of the smart devices.
The list of supported devices is different according to the smart device.
1. Refer to the manufacturer's website of your smart device to find out whether a
reader is available for your device, and how it is installed.
2. Install the required QR code reader software on your device.
3. Start the reader.
4. On the R&S SMB100B, select "System Config > Remote Access".
5. In the "Remote Access" dialog, select the "QR-Code" tab.
6. Scan the QR code of the instrument with your smart device.
7. On the device, decode the scanned QR code and pass it to the web browser.
A dialog opens requesting the password for the VNC connection.
8. Enter the password and confirm with "OK".
The default password is instrument.
After the connection is established, the current screen of the signal generator is
displayed and the instrument can be remotely operated.
To operate the instrument using VNC