Rohde & Schwarz R&S SMB100B - List Mode File Operation

Remote control commands
R&S
®
SMB100B
482User Manual 1178.3711.02 ─ 08
Rohde & Schwarz parameter SCPI parameter Applies to the list mode parameters:
AUTO IMMediate [:SOURce<hw>]:LIST:MODE AUTO
SINGle BUS
[:SOURce<hw>]:LIST:MODE AUTO or
[:SOURce<hw>]:LIST:MODE STEP
EXTernal EXTernal
[:SOURce<hw>]:LIST:MODE AUTO or
[:SOURce<hw>]:LIST:MODE STEP
Parameters:
<Source> AUTO | IMMediate | SINGle | BUS | EXTernal
AUTO|IMMediate
The trigger is free-running, i.e. the trigger condition is fulfilled
continuously. The selected list is restarted as soon as it is fin-
ished.
SINGle|BUS
The list is triggered by the command [:SOURce<hw>]:LIST:
TRIGger:EXECute. The list is executed once.
EXTernal
The list is triggered externally and executed once.
*RST: AUTO
Example: See Example"Create an RF list and activate the list mode"
on page 474.
Manual operation: See "Mode" on page 140
[:SOURce<hw>]:LIST:RUNNing?
Queries the current state of the list mode.
Return values:
<State> 1 | ON | 0 | OFF
1
Signal generation based on the list mode is active.
Example: See Example"Create an RF list and activate the list mode"
on page 474.
Usage: Query only
12.15.6.2 List mode file operation
The following section covers basic commands to file handling in list mode.
[:SOURce<hw>]:LIST:CATalog?.......................................................................................483
[:SOURce<hw>]:LIST:DELete..........................................................................................483
[:SOURce<hw>]:LIST:DELete:ALL................................................................................... 483
SOURce subsystem